Member-only story
Open Source Pulse Oximeter
Things used in this project
Hardware components :
Maxim Integrated MAX30102 Pulse and Heartrate Sensor
DFRobot Gravity I2C OLED-2864 Display
Software apps and online services:
The entire device is designed around an Arduino Nano that is mounted on a piece of 44mm by 30mm perfboard. First, wires get soldered to the VIN, GND, SDA, and SCL pins of the sensor and then run underneath the bed piece to the Arduino Nano.
Next, the connector for the OLED is attached to the Nano and then run up to the display itself.And finally, the entire electronics assembly is slid into the housing and secured with a couple of 3mm screws.
After the electronics have been inserted, simply attach the OLED screen to the top piece and secure it to the rest of the chassis with a couple of 3mm screws. You can test its…
